Kistler MiniDyn 9119AA1 User Manual

MiniDyn Multicomponent Dynamometer up to 4 000 N, Type 9119AA1
Page 6 9119AA1_002-622e-02.15
2.2 Hints for Handling this Device
 You must only work with the dynamometer in specified
environmental and operating conditions
 Insulation resistance is crucial for piezoelectric
measurements; it must be about 100 TΩ
(but at least
10 TΩ)
 To obtain this value, all the plug connections must be
kept scrupulously clean and dry
 The insulation resistance can be measured with a Type
5493 insulation tester
 Protect the device signal output against contamination
and do not touch it with your fingers. Put on the
supplied cover if the connection is not assigned
 The connecting cable (connecting cable from the
dynamometer to the charge amplifier input) has high
insulation. Only specified connecting cables must be
used
 The connecting cable should not be removed from the
dynamometer
 When the dynamometer is not being used, keep it in
the supplied packing case to protect it
 During long-term measurements, make sure that the
dynamometer temperature stays as constant as possible

Kistler MiniDyn 9119AA1 Specifications

General

Brand	Kistler
Model	MiniDyn 9119AA1
Category	Measuring Instruments
Language	English