16 | USING THE PASTA PRESS
USING THE PASTA PRESS
OPTIONAL: If desired, attach the next
pasta plate, using the directions in the
“Assembling the Pasta Press” section�
NOTE: Allow Stand Mixer to rest for at
least 1 hour after extruding 2 consecutive
pasta dough recipes�
IMPORTANT: After removing the auger
from the press housing, be sure to clean
any dried dough from the auger� See
“Care and Cleaning” for details�
3
Unscrew the pasta ring to remove�
If pasta ring is too tight to remove
by hand, slip the wrench side of the
combo tool over the grooves, and
turn as shown� Once the pasta ring
is off, pop out the pasta plate�
4
Use the combo tool hook to pull the
auger from the Pasta Press housing�
W10829435B_01_EN_v01.indd 16 3/4/16 3:08 PM
To Next Page
Loading...
