it locks into place.
PlaCe the mini'bowl inside the work
bow! over the power shaft. Rotate the
mini-bow! unti! the tabs on the top edge
of the bow! drops into the indents on
the top of the work bowl.
uoti! Jt falls nto place. Press down firmly
to lock it into place.
Insta!l the _ork bow! Cover, being Sure
it locks into placel
To remove the miniLbOWl after
processing,remoyethemini:b_adeby
pulling straight up on the capl Then lift
the bow! straight UP and out, using the
two finger grips located along the top
edge of the bowl.
To Next Page
Loading...
