Kitchenarm KA8520 - Page 46

TROUBLE SHOOTING TECHNICAL PROBLEMS
5. Something Is Burned With Smoke Coming Out Of The Vent
POSSIBLE CAUSE: Ingredients spilled into the oven, or baked products such as
breadcrumbs have collected on the heating elements or inside the oven, causing them
to be burned by the heating elements.
SOLUTION: Stop and unplug the bread maker and allow to cool completely before
cleaning. Make sure to clean the bread maker after each use. Please refer to "CLEANING
AND MAINTENANCE" session on Page 39 for guidelines.
- The bread maker may emit a little smoke and / or odor during first time use. This is
normal for a newly manufactured appliance. Make sure the appliance has sufficient
ventilation.
6. Smoke Still Comes Out During Baking After Initial Baking
POSSIBLE CAUSE: (a) After the initial baking for burning off the protective oil, there might
still be some leftover protective oil on the heating elements. (b) The bread pan leaks.
SOLUTION: If CAUSE (a), this does not indicate any malfunction. Rest assured, the
smoke won't get into the bread, and will completely disappear after a few uses. If
CAUSE (b), please contact KitchenArm Product Warranty Service for a brand new
replacement bread pan for free.
7. Ingredients Not Blending But Motor Is Running
POSSIBLE CAUSE: Bread pan or kneading paddle may not be installed properly.
SOLUTION: Make sure kneading paddle is securely attached on the rotating shaft.
Please refer to “Attach Kneading Paddle To Rotating Shaft” sub-session on Page 18.
8. Remaining Time Is Counting Down But Bread Maker Is Not Doing Anything
POSSIBLE CAUSE: (a) The bread pan is not securely installed to the oven base or it gets
loose during the KNEAD cycles due to the unsecure install, triggering the machine's
protection system to quit kneading or heating. (b) The bread maker is heating up while the
display shows "PREHEAT", or the bread maker is resting while the display shows "REST"
SOLUTION: If CAUSE (a), please exit the current menu by long pressing the STOP
button, take out the bread pan and securely install it back to the oven base, then start
the menu again. If CAUSE (b), this does not indicate any malfunction.
9. Bread Maker Stopped With The Display Showing The Initial Status Of The Menu
POSSIBLE CAUSE: There was a power outage for more than 15 minutes.
SOLUTION: Discard the unfinished bread and start the process again from the beginning
using new ingredients.
10. Viewing Window Is Blurred With Condensations
POSSIBLE CAUSE: May occur during kneading or rising cycles.
SOLUTION: This does not indicate any malfunction. It may occur during kneading or
rising cycles, and the condensations usually disappear during BAKE.
ZAs -