19
3. The digital TEMP display shows the pre-set temperature, and in 5
seconds, the Programmable Temperature Kettle will begin to heat.
The digital thermometer will revert to the current water temperature
and begin to rise until the target temperature is reached.
4. At the completion of any TEA or BOIL cycle, 3 tones will sound
as the Programmable Temperature Kettle advances to WARM.
NOTE: If the Kettle is accidentally switched ON without sufcient water,
a boil-dry protection device will automatically turn the unit OFF.
(See boil-dry protection explanation.)
WARM
5. If the WARM button is pressed before any TEA or BOIL cycle begins,
the WARM cycle will be cancelled and the unit will turn OFF when the
target temperature is reached..
CAUTION: To avoid a risk of splashing, make sure the lid is securely
closed onto the Programmable Temperature Kettle before operating. Pour
slowly and be careful not over-tilt the Programmable Temperature Kettle.
CAUTION: Do not touch hot surfaces!
6. To reheat, check the water level to ensure it is above the MIN water
level. If necessary, add more water before returning the Programmable
Temperature Kettle to the power base.
7. When not in use unplug the power cord from the wall outlet.
Allow the unit to cool completely before cleaning. Empty the
Programmable Temperature Kettle after each use. Do not allow
water to sit in the Programmable Temperature Kettle overnight.
See User Maintenance Instructions.
+ and –
8. Press + or - to increase or reduce heating temperature in 5ºF
increments (Figure 3). After 5 seconds, the Programmable Temperature
Kettle will begin to operate. When the target temperature is reached,
3 tones will sound.
To Next Page
Loading...