CAUTION
■
Before disassembly and reassembly
Safety Precaution
Mandatory
Mandatory
Mandatory
The disassembly and reassembly procedures are described based on the representative model.
Note that components may be slightly different for different capacities.
The specications may be changed without prior notice and may be different from the actual products.
•
Only competent persons with expertise and experience must disassemble/reassemble the electric
chain hoist. Alternately, contact the nearest distributor or KITO. Disassembling/reassembling
improperly causes death or severe injury.
Perform disassembly and reassembly in correct procedures as described in the manual.•
Do not extend the load chain.•
Before reassembling the parts such as gear, clean and remove oil and dust on them.•
Especially when a plastic hammer is used, clean them thoroughly so that no chip of the
hammer
remains inside.
Prepare anti-loosening (screw lock) for bolts. Apply it to the specied locations.•
Use only authorized parts for replacement.•
Failure to follow these instructions may result in death or severe injury.
•
When reassembling, follow the instructions below.
Before reassembly, remove dust and oil on the part to be reused.•
Insert snap rings completely in the groove.•
Assemble the load chain without torsion.•
Failure to follow these instructions may cause bodily injury or loss of property arising from damaged product
or dropped parts.
•
When reassembling, replace the following parts with new ones.
Gear oil (type and required amount of oil vary depending on the specication and main body size. •
Refer to page 24.)
Packing•
Grease•
Oil seal•
Snap ring•
O ring•
Liquid gasket•
Failure to follow these instructions may cause bodily injury or loss of property.
NOTE
DANGER
To Next Page
Loading...
Need help?
General
