In order to use the Cooling feature, the water deposit must be filled adequately. If you are only
using the KLIM Fresh as a regular fan, you can leave the deposit empty.
It is recommended to use the provided bottles
to keep the water in the deposit cold for longer
periods. Simply unscrew the bottle cap and
add water until it reaches the MAX mark.
Place the bottles in the freezer until they are
completely frozen. You can now place them
inside the deposit as explained in the next
section.
Hint: Once you have used a bottle, put it back
in the freezer to have it ready for next time.
Replace the bottles regularly to keep the
water in the deposit cold for longer.
Switch off the power before
manipulating the water deposit!
1. Turn the water deposit lock to open it
2. Pull the deposit out
3. Add two ice bottles and clean, cold water
4. Ensure you have not exceeded the MAX
mark on the water level indicator
5. Close the water deposit
6. Turn the lock again to secure the deposit
Water deposit lock
Remember to check the water
level indicator!
Add ice bottles and water
THE WATER DEPOSIT
Ice bottles
Filling the water deposit
W h e n t h e C o o l i n g ( )
function is active, water
levels will gradually drop
as water evaporates. Make
sure you regularly refill the
deposit so that the water level does not
drop below the MIN mark on the water
level indicator.
You can also simply deactivate the
Cooling function until you refill the
deposit.
4
To Next Page
Loading...