Klipsch CP-6 - Step 2 (Continued): Using Supplied Bracket; Using Supplied Bracket for Mounting

STEP 2 (CONTINUED)
A.
c.
n. :
1
'
Speaker
l.JI-+--- Wires
I
i
Qi
15+-~
Use #10-#12, 2.5-3 INCH ),··=:·~.
1
•
Pan Head Screws q ' :
7
1
'----r""
IF USING SUPPLIED BRACKET
A. Run speaker wire through hole in bracket back and attach wall
, bracket
to wall
B. Slide speaker partially onto bracket arms and channel wire
from back
to front
B.
D.
C. To keep speaker on bracket while adjusting use Phillips head
screwdriver and
partially screw in front top/bottom bracket
screws (2-3 revolutions)
then gently pull out speaker to detente
position
3/4ths of way on bracket.
D. WITH SPEAKER STILL PULLED OUT TO FIRST "STOP"
POSITION ON BRACKET adjust speaker to desired angle on wall.