Please dispose
of
any used batteries
properly,
following any
local
regulations.
Do
not incinerate.
WARNING:
Do
Not
Open!
Risk
of Electrical Shock. Voltages
in this equipment are hazardous to life. No user-serviceable
parts inside. Refer
all
servicing
to
qualified service personnel.
Place
the equipment near a main power supply outlet
and
make
sure that
you
can
easily
access
the power breaker switch.
WARNING:
This product
is
intended to
be
operated
ONLY
from
the
AC
Voltages
listed
on the back panel
or
included power
supply
of
the product. Operation from
other
voltages
other
than those indicated may cause irreversible damage
to
the
product and void the products warranty. The use
of
AC
Plug
Adapters
is
cautioned because
it
can
allow
the product
to
be
plugged into voltages in which the product
was
not designed
to
operate.
If
the product
is
equipped with a detachable
power cord, use only the type provided with your product
or
by your
local
distributor
and/or retailer. If
you are unsure
of
the correct operational voltage, please contact your local
distributor and/or retailer.
EU
COMPLIANCE INFORMATION
Eligible
to
bear the
CE
mark;
Conforms to European Union Low
Voltage Directive
2006/95/EC;
European Union
EMC
Directive
2004/108/EC; European Union
Rest
riction
of
Hazardous
Sub-
stances
(RoHS)
Directive
2002/95/EC;
European Union
WEEE
Directive 2002/96/EC;
European Union Eco-Design Directive
2009/125/EC;
European; European Union
Rad
io and Telecom-
munications Terminal Equipment
(R&TTE)
Directive
1999/5/EC.
This product contains batteries that are covered under the
2006/66/EC
European Directive, which cannot
be
disposed of
with normal household
waste.
Please follow local regulations
You
may obtain a free copy of the Declaration
of
Conformity
by
contacting your
dealer,
distributor, or Klipsch
Group,
Inc.'s
worldwide headquarters.
Contact
information
can
be
found here: http:/
/www.klipsch.com/Contact-
Us
WEEE
NOTICE
Note: This mark applies only to countries within the Euro-
pean Union (EU) and Norway.
~
This
appliance
is
labeled in accordance with European
A
Directive
2002/96/EC
concerning waste
of
electrical
- and electronic equipment
(WEEE)
. This label indicates
that
this product should not
be
disposed
of
with household
waste. It should be deposited
at
an appropriate facility
to
enable recovery and recycling.
FCC
AND
CANADA EMC COMPLIANCE INFORMATION
This device complies with
part
15
of
the
FCC
Rules. Operation
is
subject
to
the following two conditions:
(1)
This device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference
that
may cause undesired operation.
NOTE
:
This equipment has been tested and found
to
comply
with the
limits
for
a Class
B digital device, pursuant
to
part
15
of
the
FCC
Rules. These
limits
are designed
to
provide reason-
able protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and,
if
not
installed and used in
accordance with the instructions, may cause harmful interfer-
ence
to
radio communications. However, there
is
no guarantee
that
interference will
not
occur in a particular installation.
If
this equipment does cause harmful interference
to
radio
or
television reception, which can
be
determined by turning the
equipment
off
and
on,
the user
is
encouraged to
try
to
correct
the interference by one
or
more
of
the following measures:
Reorient
or
relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect
the equipment into an outlet on a
circuit different
from
that
to
which the receiver
is
connected.
Consult
the dealer
or
an experienced radio/TV technician
for help.
Approved under the verification provision
of
FCC
Part
15
as
a
Class
B Digital Device.
Caution: Changes
or
modifications not expressly approved by
the manufacturer could void the user's
authority
to
operate
this device.
Caution:
To
comply with the limits
of
the
Class
B digital device,
pursuant
to
Part
15
of
the
FCC
Rules, this device
is
to
comply
with
Class
B
limits.
All peripherals must be
sh
ielded and
grounded. Operation with non-certified peripherals
or
non-
To Next Page
Loading...
