RF-7 III
FLOORSTANDING SPEAKER
SPECIFICATIONS
F REQ UE NC Y R E SP ON SE 3 2–25 kH z + /– 3 dB
POWER HANDLING 250W / 1000W peak
SENSITIVITY
100 dB @ 2.83V / 1M
NOMINAL IMPEDANCE 8 ohms compatible
HIGH FREQUENCY HORN 8.5” square 90˚ x 90˚ Tractrix
®
Horn
HIGH FREQUENCY DRIVERS 1.75” (4.45cm) titanium diaphragm compression driver
CROSSOVER FREQUENCY 1,300 Hz
LOW FREQUENCY DRIVERS Two 10” (25.4cm) Cerametallic cone woofers
INPUTS Dual binding posts / bi-wire / bi-amp
ENCLOSURE TYPE
Dual chambered, bass-reflex — via dual rear-firing
Tractrix ports
HEIGHT 49” (124.5cm) including plinth
WIDTH 13.875” (35.2cm) including plinth
DEPTH 17.875” (45.4cm) including plinth
WEIGHT 97 Ibs (44.1kg)
All specifications are subject to change without notice. ©2017 Klipsch Group, Inc. Klipsch, Keepers of the Sound and Tractrix
are registered trademarks of Klipsch Group, Inc. a wholly-owned subsidiary of Voxx International Corporation.
3502 WOODVIEW TRACE INDIANAPOLIS, IN 46268 | KLIPSCH.COM
*
Sensitivity in average listening room
FINISH OPTIONS
Black Ash
Cherry
Walnut
DESIGNED AND MADE IN THE USA
USING DOMESTIC AND IMPORTED COMPONENTS
The Klipsch RF-7 III speaker is a testament to the quality that Klipsch
demands from each and every one of its audio products. Remember
great sound? We do, too. The RF-7 III enclosure is made in the USA, by
proud craftsmen in Hope, Arkansas. Just like Paul W. Klipsch (PWK)
intended.
NEW 1
3
/
4
TITANIUM DIAPHRAGM COMPRESSION DRIVER
The compression driver features a new phase plug design to improve
phase coherency at the throat of the horn, resulting in improved
sound pressure linearity at high frequencies.
90° x 90° TRACTRIX
®
HORN
The redesigned Tractrix Horn utilizes a circular horn throat paired to
a square horn mouth to further improve high-frequency response and
extension, while enhancing imaging and dynamics. The compressed
molded rubber construction adds high frequency damping to reduce
harshness and improve detail. This creates the cleanest, most natural
sound possible.
SPUN COPPER CERAMETALLIC WOOFERS™
Cerametallic woofers represent the pinnacle of Klipsch driver design,
maintaining exceptional rigidity, and lightweight construction, for
minimal cone breakup and distortion. When paired with the Tractrix
horn-loaded compression driver, it provides speaker efficiency
highest in its class.
NEW TRACTRIX
®
PORT
Utilizing Tractrix geometry, the new RF-7 III ports allow for the
most efficient air transfer from the cabinet — for the cleanest, most
powerful low frequency response on the market.
DUAL CHAMBERED ENCLOSURE DESIGN
The new bifurcated enclosure allows each 10” driver and port to
work independently from the other. This improves the linearity of
both drive systems, and minimizes standing wave problems inside
the cabinet that can cause frequency anomalies in the sensitive
midrange frequencies.
CAST FRAME WOOFER DESIGN
Each 10” woofer feature a heavy-duty cast aluminum frame for
resonant-free operation. In addition, each woofer incorporates a dual
shorting-ring magnet structure design to eliminate modulation of the
magnetic flux resulting in improved linearity
of cone movement.
FURNITURE GRADE WOOD VENEERS
RF-7 III enclosures all utilize furniture grade wood veneers, and are
available in Black Ash, Cherry & Walnut.
To Previous Page
Loading...
Need help?
General
