Remember that practice makes perfect and this is also true in
respect to the Klom Electronic Pick Gun. You must practice using
the tool to get used to handling it and to learn the correct feel
and touch to ensure rapid results when using it.
However, it is also important that the correct technique is practiced so that you
do not pick up bad technique that will hamper your success. Bad technique
can also lead to the tool being damaged and certainly can cause the probes
to become bent or snapped.
The first thing that you want to do is to look at the gun and make
sure that the amount of lift of the probe will not be too excessive
or too minimal.
I like to start with less lift and increase it gradually. However, over time you will
probably ignore this adjustment setting instead preferring to leave the amount
of lift at a setting that you were happy with previously.
Turn the top adjusting screw so that it is as far into the casing of the lock head
as it can go. This will reduce the lift and motion of the pick gun. You now want
to adjust it back, i.e. so that the screw moves back out of the lock head, so that
more movement of the probe is permitted.
Try and adjust it so that you have a very slight level of movement. This can
always be adjusted to a greater level of movement later but for now just start
off with a minimal
1
2
Buy the
KLOM EPG from
Withoutakey.co.uk
To Next Page
Loading...