Before you do anything with the Klom it is recommended that you carry out the
following steps.
The first thing that you will need to do after receiving your Klom EPG
is to get it fully charged.
Once you plug the charger in to an adapter and set it charging
you will notice a red light on the charger unit. This red light will
change to a green light once the Klom is fully charged.
Whilst the unit is charging you can attach the ‘U’ shaped clip to
the head piece. It is the U shaped clip that will actually hold the
picks/probes in place.
Locate the U clip and the bolt from
the box of attachments and fit into
place. You don’t need to tighten it
fully until you have inserted a pick as
well. So move onto the next step.
1
2
To Next Page
Loading...