KMART 12 - Handlebar and Stem Assembly; Stem to Fork Assembly

10
Do not over tighten the stem bolt. Over tightening the stem bolt can damage
Make sure the stem is aligned with the front wheel and tighten stem bolt.
1. Assemble the stem to the fork:
If necessary, assemble the stem bolt (4), washer (5), and wedge nut (2) to the stem (1).
Turn the stem bolt only four revolutions into the wedge nut (2).
Point the stem toward the front of the bicycle and put it into the locknut (6).
Put the stem at a comfortable height for the rider and tighten the bolt firmly.
Normal used stem types as shown below.
Make sure you can not see the MIN-IN mark on the stem above the locknut.
Tighten the stem bolt just enough that the stem will not fall into the locknut.
WARNING:
WARNING:
To prevent steering system damage and possible loss of control, the
MIN-IN (MINIMUM INSERTION) mark (3) on the stem must be inside the locknut.
the steering and cause loss of control.
2
2
2
1
1
1
3
3
3
5
5
5
4
4
4
Four-bolt
Stem: