14
1. Attach the upper cable to the brake lever. Ensure that the
adjusting barrel is fully tightened in the brake lever.
2. Pull the link wire on the rear brake assembly until the brake
shoes are touching the rim wall and tighten the brake bolt.
3. Ensure that the brake shoes are positioned evenly with the
side surface of the rim.
Brake Cable
Installation
Attaching the Front Brake Cable
(For Bicycles equipped with a Front Brake)
1. Open the brake lever and place the barrel end of the cable
into the lever.
2. Feed brake cable through cable adjuster and through
anchor bolt. Secure anchor bolt firmly.
3. Fasten brake caliper to fork by sliding brake mount bolt
through center hole in fork. Secure brake mount bolt firmly.
4. Refer to the next section for Braking System Adjustment.
To Next Page
Loading...