EasyManua.ls Logo

KMT STREAMLINE S50 - Page 170

Default Icon
203 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
LUBRIPLATE
MATERIAL SAFETY DATA SHEET
Section 1
PRODUCT NAME OR NUMBER: FORMULA:
LUBRIPLATE Super FML-0, FML-1, FML-2 Calcium Soap, USP Mineral Oil and Additives
GENERIC/CHEMICAL NAME: NSF Registration No’s:
Petroleum Lubricating Grease 125742, 125740, 125741
Manufacturer's Name: Emergency Telephone Number:
Fiske Brothers Refining Co. 1-800-255-3924 - CHEM-TEL (24 hour)
Address: Telephone Number for Information:
1500 Oakdale Ave., Toledo, Ohio 43605 - 129 Lockwood St., Newark, NJ 07105 419-691-2491 - Toledo Office
Section 2 - Hazardous Ingredients/Identity Information
Hazardous Components OSHA PEL ACGIH TLV Other Limits Recommended % (optional)
Non-hazardous
Hazardous Material Identification System (HMIS): Health - 1, Flammability - 1, Reactivity - 0
Not a Controlled Product under (WHMIS) - Canada Special Protection: See Section 9
Section 3 - Health Hazard Data
Threshold Limit Value: 5 mg/m
3
for oil mist in air. OSHA Regulation 29 CFR 1910.1000
Effects of Overexposure: Prolonged or repeated skin contact may cause skin irritation. Product contacting the eyes may cause eye
irritation. Human health risks vary from person to person. As a precaution, exposure to liquids, vapors, mists and fumes should be
minimized. This product has a low order of acute oral toxicity, but minute amounts aspirated into the lungs during ingestion may cause mild
to severe pulmonary injury.
Carcinogenicity: NTP? No IARC Monographs? No OSHA Regulated? No
Section 4 - Emergency and First Aid Procedures
EYE CONTACT: Flush with clear water for 15 minutes or until irritation subsides. If irritation persists, consult a physician.
SKIN CONTACT: Remove any contaminated clothing and wash with soap and warm water. If injected by high pressure under skin,
regardless of the appearance or its size, contact a physician IMMEDIATELY. Delay may cause loss of affected part of the body.
INHALATION: Vapor pressure is very low and inhalation at room temperature is not a problem. If overcome by vapor from hot product,
immediately remove from exposure and call a physician.
INGESTION: If ingested, call a physician immediately. Do not induce vomiting.
Section 5 - Fire and Explosion Hazard Data
Flash Point (Method Used): COC - 435
o
F Flammable Limits: LEL 0.9% UEL 7.0%
Extinguishing Media: Foam, Dry Chemical, Carbon Dioxide or Water Spray (Fog)
Special Fire Fighting Procedures: Cool exposed containers with water. Use air-supplied breathing equipment for
enclosed or confined spaces.
Unusual Fire and Explosion Hazards: Do not store or mix with strong oxidants. Empty containers retain residue.
Do not cut, drill, grind, or weld, as they may explode.
KMT 20416107

Table of Contents

Related product manuals