PRODUCT NAME OR NUMBER - LUBRIPLATE Super FML-0, FML-1, FML-2
Section 6 - Physical/Chemical Characteristics
Boiling Point: >550
o
F Specific Gravity (H
2
O = 1): 0.90 - 0.91
Vapor Pressure (mm Hg.): <0.01 Melting Point: Semi-solid
Vapor Density (AIR = 1): >5 Evaporation Rate: <0.01
(Butyl Acetate = 1)
Solubility in Water: Negligible
Appearance and Odor: Smooth, white grease with mineral oil odor.
Section 7 - Reactivity Data
Stability: Unstable Conditions to Avoid: N/A
Stable X
Incompatibility (Materials to Avoid): Avoid contact with strong oxidants like liquid chlorine, concentrated oxygen.
Hazardous Decomposition or Byproducts: May form SO
2
. If incomplete combustion, Carbon Monoxide.
Hazardous Polymerization: May Occur Conditions to Avoid: N/A
Will Not Occur X
Section 8 - Spill or Leak Procedures
Steps to be taken in case material is released or spilled:
Scrape up grease, wash remainder with suitable petroleum solvent or add absorbent. Keep petroleum products out of sewers and
watercourses. Advise authorities if product has entered or may enter sewers and watercourses.
Waste disposal method:
Assure conformity with applicable disposal regulations. Dispose of absorbed material at an approved waste disposal facility or site.
SARA/TITLE III, Section 313 Status - Zinc Compounds - <6%
Section 9 - Special Protection Information
Respiratory Protection (Specify type): Normally not needed
Ventilation Local Exhaust: Used to capture fumes and vapors Special: N/A
Mechanical (General) Other: N/A
Protective Gloves: Use oil-resistant gloves, if needed. Eye Protection: If chance of eye contact, wear goggles.
Other Protective Equipment: Use oil-resistant apron, if needed.
Section 10 - Special Precautions
Precautions to be taken in handling and storing:
Keep containers closed when not in use. Do not handle or store near heat, sparks, flame, or strong oxidants.
Other Precautions:
Remove oil-soaked clothing and launder before reuse. Cleanse skin thoroughly after contact.
The above information is furnished without warranty, expressed or implied, except that it is accurate to the best knowledge of Fiske
Brothers Refining Company. The data on these sheets relates only to the specific material designated herein. Fiske Brothers
Refining Company assumes no legal responsibility for use or reliance upon this data.
Date Prepared: January, 2006 Prepared by: James R. Kontak
To Next Page
Loading...