Need help?Do you have a question about the KNIPEX 95 36 250 and is the answer not in the manual?
To release the handles, push the locking lever sideways.
Place cables onto the fixed blade and position the sickle blade onto the cable.
Close handles, push retaining latch upwards to release the sickle blade.
Suitable for cutting copper and aluminum cable and multi-core cable.
Keep gearing clean and free from dirt; occasional oiling of joints.
Meets requirements for insulated tools per DIN EN 60900 or IEC 60900.
Working live or near voltage requires trained persons and safety precautions.
Visually inspect handle insulation for damage before each use.
Observe 5 safety rules when cutting cables in electrical installations.
Wear insulating gloves and face shield for protection against electric arcs.
Handle the cable cutter by gripping insulated handles below the slip guard.
Wear additional insulating gloves and approved face shield.
Ensure clothing worn has adequate arc protection.
Separate conductors, cut individually, and cover live ends immediately.
Use insulating pliers to operate latch and pull sickle blade if cut is interrupted.
Detailed steps for unlocking the sickle blade mechanism while cutting live cables.
General| Article No. | 95 36 250 |
|---|---|
| Length | 250 mm |
| Material | Chrome vanadium steel |
| Cutting capacity (diameter) | 2.5 mm |
| Reach compliant | Yes |
| RohS compliant | Yes |
| Head | Burnished |
To Next Page