Knorr-Bremse BENDIX TIM G2 User Manual

6
7
T I M G 2 - T r a i l e r I n f o r m a t i o n M o d u l e
Date Based
Year:
Month:
Day:
Save & Exit
Exit
Distance Based
Srv mi:
Save & Exit
Exit
RSP Intervention
Test Puls:
Step 1:
Step 2:
Step 3:
Exit
Brake History
Appl vs Dem Values
Over Pressures
Exit
System Powering
ConstPower:
Stop Lamp:
Exit
Load Info
Front Axle Group
4
Bogie Load:
4
Rear Axle Group
Bogie Load:
Exit
Over Pressures
Dem >130psi:
Res >130psi:
Exit
Appl vs Dem Values
<22psi:
22-36psi:
36-58psi:
>58psi:
Exit
Pressure Info
Dem P4:
Dem CAN:
Susp P42:
Pcyl P21:
Pcyl P22:
Pcyl P2:
Res P1:
Exit
Installation Test
Start Inst. Test
Install Check
Reserv. Press
S-A Sensor:
4
S-E Sensor:
4
S-C Sensor:
S-D Sensor:
S-F Sensor:
4
S-B Sensor:
4
Demand Press:
Tilt Angle:
Exit
Menu Overview
Liftaxle control
LC Tuning:
Save & Exit
Exit
TPMS Setup
3
Enter conf. Mode
6
Learn Sensor
5
Delete Sensor
5
Vehicle param.
5
Axle param.
5
Altitude comp:
5
Change password
5
Leave conf. Mode
5
Exit
Enter conf. Mode
6
Password:
Match password
Exit
Vehicle param.
5
SAL % CIP:
FAL % CIP:
Over Temp:
Exit
Change password
5
Password:
New passw.:
Save new passw.
Exit
(Set Next Service) (Info Total) (System Info)(Info Period)
Menupoints in green are not available in BATTERY MODE
1
Displayed only if active faults are available
2
Displayed only if installation test is missing
3
Displayed only if Tire Pressure Monitoring System (TPMS) configuredDisplayed only if Tire Pressure Monitoring System (TPMS) configured
4
Displayed only if included by vehicle ABS configuration
5
Displayed only if TPMS configuration mode enteredDisplayed only if TPMS configuration mode entered
6
Displayed only if TPMS configuration mode not enteredDisplayed only if TPMS configuration mode not entered

Knorr-Bremse BENDIX TIM G2 Specifications

General

Brand	Knorr-Bremse
Model	BENDIX TIM G2
Category	Control Unit
Language	English