General
General General
General Operation
OperationOperation
Operation
1. Intended Use: The machine is intended for the tacking of cardboard,
insulating material, fabric, foils, leather and similar materials on surfaces of
wood, or materials similar to wood.
2. LED Status Indicator:
a. Brad Nailer LED Statuses:
i. Flashing Red LED: Nail/Staple Jam
ii. Solid Red LED: Low Battery
iii. Solid Green LED: Out of Nails
b. Charger LED Statuses:
i. Solid Red LED: Battery Charging
ii. Solid Green LED: Battery is Fully Charged
3. Battery Charging:
a. Plug the charger’s power supply into an outlet, and then plug the
battery into the charger. The charger’s LED will turn solid red to
indicate the battery is currently charging.
b. Once the battery is fully charged, the LED will turn green. The
charging process takes appox. 1 to 1.5 hours.
c. New batteries or batteries that haven’t been used for an extended
amount of time, require up to 5 charge/discharge cycles to reach full
power capacity.
d. Do not recharge batteries after use if they won’t be used for an
extended period of time.
4. Inserting and Removing a Battery Pack
a. Insert the battery pack into the grip until it clicks into place as seen in
image A
b. To remove the battery pack, press both Lock buttons simultaneously
and slide the battery out of the grip as seen in image B.
To Next Page
Loading...
General