12
ASSEMBLY INSTRUCTIONS
1. Installing front wheel and rear wheel
1a. Installing front wheel
• Turn car upside down. Place cardboard on oor, or use a soft surface, so as not to scratch the car
body.
• Turn the steering wheel rod 180 ° to the top.
• Align the front wheel shaft (L) with screw holes of the car body, and make the steering rod go
through the hole in the center of the ront wheel shaft (L).
• Fix the shaft by 8 screws (VV).
• Put an M10 washer of wheel (AA) on each side of the shaft.
• Install the shaft bearing of wheel (DD) into the center of the front wheel.
• Install the wheel.
• Put an M10 washer of wheel（AA） on each side of the shaft.
• Then put the nut (BB) on. Then use the wrench (UU) to tighten.
• Install the wheel cover (EE).
BB
DD
1a
AA
EE
UU
Steering wheel rod
4
VV
VV
L
4
To Next Page
Loading...
Need help?
General