14
ASSEMBLY INSTRUCTIONS
• Install the wheel (with the drive connector installed).
• Place the M10 washer of wheel (AA).
• Tighten the nut (BB) by hand or with a wrench (UU).
Note: At this time, the nut (BB) can not be fully tightened.
• Press down shock proof plastic parts, and at the same time, press down the shaft and pull rmly
until it is installed in place.
• Install the other rear wheel in the same way (No need to pull the shaft).
• Install “L” drive on the left side and “R” drive on the right side (consistent with letters “L” and “R” on
the kid car).
1b
AA
BB
L
R
1b
L
R
To Next Page
Loading...
Need help?
General