Kobalt KPW-1500 User Manual

7
kobalttools.com
ASSEMBLY INSTRUCTIONSASSEMBLY INSTRUCTIONS
3. Slide cord hook holder (D) onto right side of
power washer unit (C) as shown.
Note: This step does not require any screws.
High Pressure Hose Assembly
4. Screw high pressure hose (E) clockwise onto
bottom front of power washer unit (C). Pull back
collar and insert o-ring post into water outlet far
enough so collar can thread onto outlet threads
until hand tight. If it takes fewer than six turns
you have not properly tightened the high
pressure hose tting. It is easier to position the
power washer in front of you to ensure that the
threads are started correctly. Failure to properly
tighten high pressure hose will result in the hose
slipping or popping off immediately upon turning
unit on. Do not worry about damage if this
occurs–just reinstall and take extra care when
screwing on the high pressure hose tting.
Note: DO NOT use pliers or locking pliers to
tighten.
OFF/O
ON/I
1500 PSI
3
C
D
3
C
E

Kobalt KPW-1500 Specifications

General

Brand	Kobalt
Model	KPW-1500
Category	Pressure Washer
Language	English