2G0947 - 31JAN08 5-93
Diagnostics
Condition Code: 28-154
Description
This error occurs when the MICROCONTROLLER reports that it has detected
an error while attempting to read or write from its NVRAM. The error clears
only when power is cycled.
System Impact
The printer is unable to print films. The spooler is still able to accept and queue
jobs but new films will not be initiated. Films downstream of the affected
subsystem will be completed. All other films will be reprinted.
User Action
1. Shut down the IMAGER, then start the IMAGER.
2. If the error persists, call for service.
FE Action
Condition Code: 28-155
Description
This error occurs during initialization when the setpoint or offset parameters
read from NVRAM are outside their allowable values. This error is caused by
loading incorrect parameters into NVRAM or by an NVRAM error. The error
clears only when power is cycled.
System Impact
The printer is unable to print films. The spooler is still able to accept and queue
jobs but new films will not be initiated. Films downstream of the affected
subsystem will be completed. All other films will be reprinted.
User Action
1. Shut down the IMAGER, then start the IMAGER.
2. If the error persists, call for service.
FE Action
Web Portal Message Log Message DICOM Message Severity
Processor: Internal
Communications Failure
Processor microcontroller failed
to read/write to NVRAM
ELEC DOWN 0-Fatal
Web Portal Message Log Message DICOM Message Severity
Processor: Internal
Communications Failure
Invalid Processor parameters
read from NVRAM
PROC DOWN 0-Fatal
To Next Page
Loading...
