Kodak Ektalite 500 - Installation for the MECHANISM ASSEMBLY

SERVICE MANUAL Removals and Installations
23JUL01
SM5766-1
Page
22 of 96
8 Disconnect all wires connected to the MECHANISM ASSEMBLY:
• 1 yellow wire from J105
• 1 orange wire from J105
• 1 green wire from POWER CORD
• 2 green ground wires from the lower MECHANISM ASSEMBLY
9 Remove the FOCUS KNOB from the FRONT PANEL.
Important
For the Models 1500 and 2000 only, disconnect the short, gray wire connected to the AUTO-
FOCUS DEFEAT SWITCH.
10 Remove the 3 Torx SCREWS from the LENS MOUNT ASSEMBLY.
11 Lift and move the LENS MOUNT ASSEMBLY up.
12 Do the removal for the MOTOR.
13 Remove the 3 Torx SCREWS from the MECHANISM ASSEMBLY.
14 Loosen the SCREW on the STABILIZER WALL approximately half way.
15 Models 1500 and 2000 Only: Remove the SCREW from the DARK SHUTTER SWITCH.
16 Remove the DARK SHUTTER SWITCH or DUAL SWITCH.
17 Remove the MECHANISM ASSEMBLY.
Installation for the MECHANISM ASSEMBLY
Important
To insert the SELECT BUTTON into the hole in the SELECT LEVER when installing the
MECHANISM ASSEMBLY, hold the SELECT BUTTON completely down.
1 Do the removal for the MECHANISM ASSEMBLY in reverse order.