Kodak Ektalite 500 - Removal for the AUTO-FOCUS BRACKET ASSEMBLY - 1500 and 2000 PROJECTORS Only

SERVICE MANUAL Removals and Installations
23JUL01
SM5766-1
Page
23 of 96
Removal for the AUTO-FOCUS BRACKET ASSEMBLY - 1500 and
2000 PROJECTORS Only
Warning
Dangerous Voltage
1 Disconnect the main power.
Important
There is no AUTO-FOCUS BRACKET ASSEMBLY for the Model 1000.
2 Do the removal for the LOWER HOUSING ASSEMBLY.
3 Disconnect the 3 CONNECTORS on the MAIN BOARD. It is not necessary to disconnect
the CONNECTORS next to the LOWER LIGHT BAFFLE ASSEMBLY.
4 Lift the MAIN BOARD up.
5 Cut and remove the necessary WIRE TIES.
6 Disconnect the 2 violet wires from the CYCLE SOLENOID on the SMALL BOARD.
7 Pull the SMALL BOARD up.
8 Do the removal for the MECHANISM ASSEMBLY.
9 Remove the Torx SCREW from the WORM PULLEY.
10 Remove the WORM PULLEY.
11 Remove the 2 Torx SCREWS from the CYCLE SOLENOID.
12 Remove the CYCLE SOLENOID.
13 Remove the Phillips SCREW from the AUTO-FOCUS BRACKET ASSEMBLY.
14 Pull and remove the AUTO-FOCUS BRACKET ASSEMBLY through the hole where the
CYCLE SOLENOID was located.