Kodak Ektalite 500 - ZERO POSITION SWITCH - 2000 PROJECTOR Only

SERVICE MANUAL Adjustments
23JUL01
SM5766-1
Page
45 of 96
ZERO POSITION SWITCH - 2000 PROJECTOR Only
Important
It is necessary use make a 5/16 in.
WRENCH to do this adjustment.
1 Energize the projector.
2 Connect the DIGITAL VOLT METER
(DVM) between PINS B5 and B6 of the
12 PIN APPLICATIONS PLUG.
3 With no TRAY installed, the DVM
should measure •.
4 Install a TRAY.
5 To move the TRAY out of the zero
position, press the “FORWARD” or
“REVERSE” BUTTONS; the DVM
should measure 0 W.
6 5 4 3 2 1
a
b
A091_4021AA
12-PIN APPLICATION PLUG
A091_4021ACA