SERVICE MANUAL Adjustments
23JUL01
SM5766-1
Page
51 of 96
PHOTOCELL
Warning
Dangerous Voltage
1 Disconnect the main power.
2 Do the removal for the LOWER
HOUSING ASSEMBLY.
Important
It is necessary to use a FAN COVER TOOL.
3 Install the FAN COVER TOOL over the
FAN area and the LAMP MODULE.
4 Energize the projector.
5 Set the projector to the LO-LAMP
position.
6 Install and hold the AUTO FOCUS
TARGET SLIDE TL-3002 until it is fully
seated in the GATE MECHANISM.
7 Look through the PROJECTION LENS
hole and observe the focus light path
on the AUTO-FOCUS TARGET SLIDE
TL-3002. Check that the light path is
correct. If not, do the adjustment for the
FOCUS LIGHT PATH.
Warning
Dangerous Voltage
8 Disconnect the main power.
A091_4032GA
CIRCUIT BOARD
PHOTOCELL
PHOTOCELL
HOUSING
POST (2)
A091_4032GCA
PHOTOCELL
MASK
FILTER (2)
wratten
To Next Page
Loading...
