Quick Reference -- The ultimate reference for Kodak EKTAPRO Slide Projectors
40
by Kodak GmbH Stuttgart, PT CMS edition 1/2001 -QR-Epro.pm6.5
Extra Bright Lamp Module
Safety Precautions
√ Do not use a lamp type EXW/15 h for the projector (higher temperature - lamp not
available from Kodak).
√ Consider the room temperature! It may not exceed 35 degrees C!
√ High-Light-Mode (models 7010, 7020, 9010, 9020): Slide projection time per
slide may not exceed 1 minute!
If these hints are not considered, mounts may deform!
According to a temperature increase in the slide gate which, therefore, needs more careful
handling when using slides, mounts and lamps.
With the higher light output of the Extra Bright Lamp Module the temperature in the slide gate rises.
To enable a smooth operation following should be considered:
√ Use only light respectively light gray slide mounts (e.g.
Wess slide mounts). Slide mounts with only one dark or
black side have to be sorted in with the light side facing the
lamp. Please pay special attention when sorting your slide
mounts in rear projections:
n Slide Gate Temperature
Lamp Module
EXR lamp FHS lamp EXY lamp
Extra Bright 80 58 49
Extra Bright in High Light Setting 90 64 56
Extra Bright in Economy Setting 65 50 42
Standard 65
Standard +10 75
Tem
To Next Page
Loading...
