A-61670 August 2014 3-11
Multifeed detection If Multifeed Detection has been enabled via the scanning application, you can
turn Multifeed Detection off for the rest of the current scan job.
Multifeed sensors If Multifeed Detection has been enabled via the scanning application, you can
turn on or off any or all of the five scanner sensors. When the sensors are
selected, click OK to close the window.
Printing If printing or electronic annotation (VRS only) has been enabled via the
scanning application, you can temporarily disable it on all remaining
documents in a scan job. This may be useful if rescanning a stack of
documents that have already been printed on.
Once Printing is disabled, no documents will be printed on (or images
annotated on) until the Printing option is enabled.
If you want to disable printing/annotation for the first document in the scan job,
then your scanning application must be set up to NOT automatically start
scanning, so that this screen can be accessed and printing/annotation can be
disabled before you start scanning.
Changing the print offset The Print Offset function allows you to temporarily move the print location on a
document (e.g., if you need to rescan a document that has already been
printed on).
When you change the print offset position, the change will stay in effect until
the scanner returns to the Idle state.
NOTES:
• The Print Offset option is only displayed on the touchscreen if the printer is
enabled.
• Print Offset does not effect annotation.
• If your scanner is configured to auto start, it is recommended that you
disable autostart if you want to use the Print Offset function for the first
document.
• For more efficient scanning, it is recommended that you set the scanner to
Pause Scanning (in the scanning application) when a multifeed occurs so
the scanner will stay enabled.
• If you set the Print Offset to a dimension that is longer than your document,
there will be no printing on your document.
To Next Page
Loading...
