4-8 A-61670 August 2014
5. Grasp the blotter strip(s) that needs to be replaced and carefully pull it off
of the channel. Discard the soiled strip according to local regulations.
6. Remove the backing from a new blotter strip.
7. Align the blotter strip in the channel.
NOTE: Improperly aligned blotter strips may cause document jams.
8. Press the adhesive side of the blotter strip down firmly into the channel.
9. If other strips need to be replaced, repeat Steps 5-8.
10. Replace the black drainage strip.
11. Close the scanner cover.
To Next Page
Loading...
