Regulatory
Information
FCC
compliance
and
advisory
Fe
This equipment has been tested and found
to
comply with
the limits for a Class Bdigital device, pursuant
to
Part
1S
of
the
FCC
Rules. These limits are designed
to
provide
reasonable protection against harmful interference in
a residential installation.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed
or
used in accordance
with
the instructions, may cause harmful interference
to
radio communications. However, there
is
no guarantee that
interference will not occur
in
a particular installation.
If this equipment does cause harmful interference
to
radio or
television reception, which can
be
determined by turning the
equipment
off
and on, the user
is
encouraged
to
try
to
correct the interference by one or more
of
the following
measures:
1) reorient or relocate the receiving antenna;
2)
increase the separation between the equipment and the
receiver;
3)
connect the equipment
to
an
outlet on a circuit
different from that to which the receiver is connected;
4)
consult the dealer or
an
experienced
radio/TV
technician for
additional suggestions.
Any changes
or
modifications not expressly approved by the
party responsible for compliance could void the user's
authority
to
operate the equipment. Where shielded
interface cables have been provided
with
the product or
specified additional components
or
accessories elsewhere
defined
to
be
used
with
the installation of the product, they
must
be
used in order
to
ensure compliance with
FCC
regulation.
Canadian
DOC statement
DOC Class B
compliance-This
Class B digital apparatus
complies
with
Canadian ICES-D03.
Observation des normes-Class
B-eet
appareil numerique
de
la
c1asse
Best
conforme a
la
norme
NMB-003
du
Canada.
Kodak
Made
in
China
for
EASTMAN
KODAK
COMPANY
Rochester,
New
York
14650
U.S.A.
©
Eastman
Kodak
Company,
2009.
MCIMR/TM:
Kodatc.
www.kodalcom,lgo/batteries
4J7212
To Next Page
Loading...
