Kodak No. 2 Folding Pocket Brownie - p-31

Be Sure
It is most important that the user of The
Brownie Developing Box experiment thoroughly
with the dummy film spool. Put this spool
through the machine a number of times until you
are perfectly familiar with all the operations and
can perform them without referring to the manual.
After the dummy spool has been unrolled see
if the white paper, representing the film in the
dummy spool, is on the outside of the loop. If it
is not, the spool has not been correctly inserted.
The film must be on the outside with the duplex
paper on the inside of the loop.
When you thoroughly understand all operations
and are ready to develop a roll of film, prepare
the developer and fixing bath for immediate use
according to direc-
tions on page 37 and
48.
1. Remove cover
from box by springing
out metal clasps, as
shown in Fig. 1.
2. Then fully un-
wind cord from roller
A. Attached to the
cord is a metal clip
called the Spool Car-
rier, in which the FIG. 1
roll of film is to be placed, as explained in para-
graph five following.
3. Lift up roller B, being careful not to pull
31