97
2. Tie one end of the tether to the adhesive mount, and the other end to the rear cover shaft.
3. Assemble the base, pre-tightening handle and adhesive mount according to the direction
illustrated in the picture. First press the base into the adhesive mount, and then rotate and
tighten the pre-tightening handle.
4. Tack the double-sided adhesive at the bottom of the adhesive mount to the object to be
used.
Double-sided adhesive is disposable. It can be purchased separately and replaced if
needed.
Pre-tightening Handle
Tether
Adhesive Mount
Double-sided adhesive
To Next Page
Loading...
