Fig.
10
Inserting rotisserie:
1
Push the
rounded end of the spit into the
receptacle drive.
2
Then put the other
end of the spit on the holding bracket.
Consider the size of the food for grilling
(e.g. roast chicken). It shall not touch
the upper or lower heating elements at
any position.
Note:
When using the rotisserie, please only use
chicken with a maximum weight of 3.5 kg.
Fig.
11
Use the provided handle to remove the
rotisserie in reverse order of inserting.
Baking and grilling
• Before each use make sure the crumb tray is
inserted below the lower heating element.
• Preheat the oven for a few minutes with the
door closed. To do so, turn the temperature
control to the desired temperature and
switch on the oven using the timer or On/
O switch.
• Prepare the food for baking. Put them on
the baking grate or baking tray.
• For fatty or wet foods use the baking tray
to avoid grease or liquids dripping o.
• Insert the baking grate or tray at the desired
height. Three insertion heights are available.
• Close the door, turn the temperature control
to the desired temperature and switch on
the product by using the timer or On/O
switch.
Caution
The upper enclosure and other parts of the
product may become very hot during use.
During operation and directly afterwards do
not touch the hot surfaces of the product.
Cleaning and care
Caution
Always unplug the product from the power
outlet and let it cool down before cleaning.
Fig.
12
Before each cleaning unplug the
product and let it cool down.
•Remove grease which possibly
dropped onto the lower heating
element with a damp cloth.
•Clean baking tray, grate, rotisserie and
clamps with a mild standard dish liquid.
•Remove the crumb tray and clean it.
Use paper towels to wipe o larger
amounts of grease.
•After cleaning insert the crumb tray
again.
•When cleaning, never use solvents
or abrasive materials, hard brushes,
metallic or sharp objects. Solvents
are harmful to human health and can
attack plastic parts, while abrasive
cleaning mechanisms and tools may
scratch the surface(s).
Replacing the oven light
Warning
Let the product cool down. Unplug the
product from the power outlet before
replacing the lamp to avoid the possibility of
electric shock.
If the oven lighting is defective, the bulb must
be replaced.
Fig.
13
First remove the lamp cap and then
turn the light bulb counterclockwise.
Replace the bulb with a lamp of the
same type (230V 25W T300, E14).
The installation is done in reverse order.
Make sure the light bulb and lamp cover
are properly in place.
• The baking mode (function) can be changed
during baking process.
• When using the timer control the heating
elements are automatically switched o
after the preset time has expired.
• For switching the oven o manually, turn
the timer/ on/o switch to position OFF.
• For opening the possibly hot door use the
handle only.
Caution
Hot steam could be emitted when opening
the oven door. Thus always open the door
carefully.
• Use oven mitts or some cloth or the
provided baking grate handle when taking
out the baking grate or tray. A hot baking
grate or tray shall only be placed on a heat
resistance surface.
• For taking out the rotisserie use the handle
provided.
• Unplug the product after use.
Caution
Depending on the type and quality of the
food, it could become very hot during grilling
/ baking. Especially foods with a high water
content, such as tomatoes, will become very
hot. Be extremely careful when grilling and
especially when removing these types of
foods.
IM_KMO4341_180306_V05_HR.indb 19 6/3/18 2:01 pm
To Next Page
Loading...
