Kohler 14/20RESA - Fuel System and Noise Hazards; Electrical and Moving Parts Hazards

TP-6803 12/11 9
Introduction
This manual provides installation instructions for
Residential/Commercial Model 14/20RESA or
14/20RESAL generator sets. See Figure 1. Refer to
TP-6804, Operation Manual, for generator set operation
and maintenance instructions.
The generator set is approved for use in stationary
applications in locations served by a reliable utility
power source.
Have an authorized distributor/dealer install the
generator set outdoors according to the instructions in
this manual. The generator set installation must comply
with the National Electrical Code (NEC) and local code
requirements. Do not install this generator set indoors.
Information in this publication represents data available
at the time of print. Kohler Co. reserves the right to
change this publication and the products represented
without notice and without any obligation or liability
whatsoever.
Read this manual and carefully follow all procedures
and safety precautions to ensure proper equipment
operation and to avoid bodily injury. Read and follow the
Safety Precautions and Instructions section at the
beginning of this manual.
zaa28533
Figure 1 14/20RESA/RESAL Generator Set
List of Related Literature
Figure 2 identifies related literature available for the
generator sets covered in this manual. Only trained and
qualified personnel should install or service the
generator set.
Literature Type Part Number
OperationManual, 14/20RESA/RESAL
Generator Set
TP-6804
Operation/Installation Manual, Model
RXT Automatic Transfer Switch
TP-6807
Service Manual,
14/20RESA/RESAL Generator Set
TP-6735
Operation Manual, OnCue Software TP-6796
Operation/Installation Manual,
Model RDT Transfer Switch
TP-6345
Installation Manual, Model RSB
Transfer Switch
TP-6486
Operation Manual, Model RSB
Transfer Switch
TP-6487
Installation Instructions, Load Control
Module (LCM)
TT-1574
Installation Instructions,
Programmable Interface Module (PIM)
TT-1584
Figure 2 Related Literature
Startup and Registration
When the generator set is installed, complete the
startup and installation checklists supplied with the
startup notification form. Complete and sign the startup
notification form and register the unit using the Kohler
online Warranty Processing System.