TP-6735 7/1790 Section 6 Disassembly/Reassembly
6. Original Design: Disconnect the latch assembly:
a. Disconnect the latch rods at the red plastic
connectors. See Figure 6-5.
b. Reach inside the enclosure to move each latch
hinge aside.
Note: With the revised latch design, no latch
disassembly is required.
7. See Figure 6-6. Remove two nuts on each side
(total of four nuts).
8. Remove one screw near the controller area.
9. Pull the right side panel up and off.
1
GM72523
1. Disconnect latch rods
Figure 6-5 Door Latch Detail (original design)
1
1. Remove 4 nuts inside the enclosure (2 left and 2 right).
2. Remove screw.
1
Note: Part of the right side panel is cut away
in this view to reveal the fasteners.
2
GM72523
Figure 6-6 Right Side Panel
To Next Page
Loading...
