TP-6735 7/17 91Section 6 Disassembly/Reassembly
10. Remove two screws and remove the front panel.
SeeFigure6-7.
GM72523
1. Remove 2 screws
1
Figure 6-7 Front Panel (air intake end panel)
11. Unplug the carburetor heater (if equipped) from the
120VAC receptacle.
12. Unplug the battery charger from the 120VAC
receptacle.
13. Disconnect the generator set engine starting
battery, negative (--) lead first.
14. Disconnect output leads or load circuit cables at
the field-connection terminal block.
15. Remove two nuts and lift off the exhaust end panel.
SeeFigure6-8.
GM72523
1
1
1. Remove 2 screws
Figure 6-8 Rear Panel (exhaust end panel)
16. From the inside of the enclosure, remove four nuts
securing the left side panel. See Figure 6-9.
17. Pull the panel up and off.
2
2
1
ADV-7876
1. Left side panel
2. Remove 4 nuts
Figure 6-9 Left Side Panel
To Next Page
Loading...
