Kohler 5EFKOD - Page 94

TP-6774 2/14a94 Section 9 Generator Disassembly/Reassembly
GM73473-A
1. Overbolts. Torque to 23 Nm (17 ft. lbs.)
2. Washers
3. Screws
4. Brush holder cover.
During disassembly, push the brushes into the holder. Secure
the brushes into position by sliding a retainer into the brush
keeping holder. Remove the brush holder and carefully pull
the leads out of the stator housing.
During reassembly, feed the brush leads inside the stator
housing up t hrough the opening. Secure the brush holder
using the original screws. Remove the brush retainer and
check alignment. See Section 8.6.
5. Gasket
6. End bracket
7. O-ring
8. Rotor assembly
9. Stator assembly
10. Alternator air outlet guard and screw
11. Lead, screw, lock washer, and plain washer
12. Alternator fan
13. Drive disk
14. Washers
15. Screws. Torque to 45 Nm (34 ft. lbs.)
16. Nuts
17. Studs. Torque to 23 Nm (17 ft. lbs.)
1
2
5
4
3
7
8
10
11
9
12
13
14
15
16
17
6
Figure 9-5 6EKOD/5EFKOD Alternator Assembly (Disassembly/Reassembly)
Follow the general torque specification found in
Appendix C of this manual unless noted above or in
Section 1.6, Torque Specifications.