Kohler COURAGE SV710-740 - Page 16


6HFWLRQ
6DIHW\DQG*HQHUDO,QIRUPDWLRQ
6SHHG&RQWURO%UDFNHW
Fastener Torque .........................................................................................................10.7 N·m (95 in. lb.) into new holes
7.3 N·m (65 in. lb.) into used holes
6WDUWHU$VVHPEO\
Thru Bolt Torque
FASCO (Inertia Drive) .........................................................................................4.5-5.7 N·m (40-50 in. lb.)
Delco-Remy (Solenoid Shi) ..............................................................................5.6-9.0 N·m (49-79 in. lb.)
Mounting Screw Torque (All)..................................................................................15.3 N·m (135 in. lb.)
Brush Holder Mounting Screw Torque
Delco-Remy Starter ..............................................................................................2.5-3.3 N·m (22-29 in. lb.)
6ROHQRLG6WDUWHU
Mounting Hardware Torque
Delco-Remy Starter ..............................................................................................4.0-6.0 N·m (35-53 in. lb.)
Nut, Positive (+) Brush Lead Torque
Delco-Remy Starter ..............................................................................................8.0-11.0 N·m (71-97 in. lb.)
6WDWRU
Mounting Screw Torque ...........................................................................................6.2 N·m (55 in. lb.)
9DOYH&RYHU
Valve Cover Fastener Torque...................................................................................6.2 N·m (55 in. lb.)
9DOYHVDQG9DOYH7DSSHWV
Valve Clearance ........................................................................................................0.101/0.152 mm (0.004/0.006 in.)
Valve Tappet to Crankcase Running Clearance ....................................................0.013/0.073 mm (0.0005/0.0029 in.)
Intake Valve Stem-to-Valve Guide Running Clearance .......................................0.038/0.076 mm (0.0015/0.0030 in.)
Exhaust Valve Stem-to-Valve Guide Running Clearance ....................................0.050/0.088 mm (0.0020/0.0035 in.)
Intake Valve Guide I.D.
New ........................................................................................................................7.038/7.058 mm (0.2771/0.2779 in.)
Max. Wear Limit ..................................................................................................7.134 mm (0.2809 in.)
Exhaust Valve Guide I.D.
New ........................................................................................................................7.038/7.058 mm (0.2771/0.2779 in.)
Max. Wear Limit ..................................................................................................7.159 mm (0.2819 in.)
Valve Guide Reamer Size
Standard ................................................................................................................7.048 mm (0.2775 in.)
0.25 mm O.S. .........................................................................................................7.298 mm (0.2873 in.)
Intake Valve Minimum Li .....................................................................................8.07 mm (0.3177 in.)
Exhaust Valve Minimum Li ..................................................................................8.07 mm (0.3177 in.)
Nominal Valve Seat Angle .......................................................................................45°