Kohler COURAGE SV710-740 - Page 84


6HFWLRQ
(OHFWULFDO6\VWHPDQG&RPSRQHQWV
)LJXUH5HPRYLQJ7KUX%ROWV
5. Remove the commutator end plate assembly,
containing the brush holder, brushes, springs,
and locking caps. Remove the thrust washer from
inside the commutator end. See Figure 7-43.
)LJXUH5HPRYLQJ&RPPXWDWRU(QG3ODWH
$VVHPEO\
6. Remove the frame from the armature and drive
end cap. See Figure 7-44.
)LJXUH6WDUWHU)UDPH5HPRYHG
7. Remove the drive lever pivot bushing and
backing plate from the end cap. See Figure 7-45.
)LJXUH5HPRYLQJ3LYRW%XVKLQJDQG%DFNLQJ
3ODWH
)LJXUH5HPRYLQJ3OXQJHU
4. Remove the two thru (larger) bolts. See Figure
7-42.
)LJXUH6ROHQRLG5HPRYHGIURP6WDUWHU