8.2
Section 8
Disassembly
Figure 8-3. Removing Oil Filter.
2. Allow ample time for the oil to drain from the
crankcase and oil filter.
3. Remove and appropriately discard the oil filter.
See Figure 8-3.
4. Use an allen wrench to loosen the adapter
nipple. Note the locating pin of the adapter and
corresponding notch in the pad of the oil pan.
Remove the nipple, washer (plastic adapters
only), and oil filter adapter. See Figure 8-4.
Figure 8-5. Removing Oil Cooler From Blower
Housing.
6. Remove the oil pump outlet tube assembly and
the oil feed tube (if not removed with nipple).
Figure 8-2. Removing Oil Fill Cap/Dipstick.
Oil Fill
Cap/Dipstick
Drain Plug
Figure 8-4. Removing Oil Filter Adapter.
5. If an oil cooler is used remove the mounting
screws securing the cooler unit to the blower
housing. See Figure 8-5.
Figure 8-6. Removing Oil Pump Outlet Tube
Assembly and Oil Feed Tube.
Oil Feed
Tube
Oil Pump
Outlet Tube
Assembly
Mounting
Screws
Adapter
Nipple
Locating
Pin
Notch
To Next Page
Loading...
