14. Remote control
fails to connect to
toilet.
A. Lower battery
B. The remote control is too far from the
toilet
C. The toilet is not yet powered on
D. The toilet is on standby mode
E. The toilet is not connected to the remote
control
A. Review “Usage and replacement of battery for remote
control” chapter and replace battery accordingly.
B. Review “Communication between remote controller and
the toilet”, and approach to the toilet
C. Power on the toilet.
D. Press “ ” button at the side panel.
E. Review “Communication between remote and toilet” and
connect toilet and remote accordingly.
15. The seat is not
warm.
A. Remote seat temp set too low.
B. Toilet is on standby mode.
A. Set seat temp to proper dial.
B. Press “ ” button at the side panel.
11. Night light does
not work
A. The night function is turned off
B. The indoor light is too bright
A. Review “auxiliary keyboard function” to activate the night
light function.
B. Please cover photoreception window completely.
12. UV sterilization
function does not
work
A. User sits on the toilet
B. The seat is covered by foreign matters
or the seat is wet
A. Please close the cover and reactivates the UV
sterilization again when unseated.
B. Remove the foreign matters or dry the seat
13. Remote is unable
to display
A. Battery exhausted
B. Battery polarities are mounted reversely
C. The remote controller does not answer.
A. Replace with new batteries
B. Reinstall properly
C. Approach to the toilet or seated.
To Next Page
Loading...
