7. Make Electrical Connections
WARNING: Risk of electric shock. To reduce the risk of electrical shock, connect the blower motor to
a properly grounded, grounding-type receptacle protected by Ground-Fault Circuit-Interrupters
(GFCI’s). Do not remove the plug grounding pins. Do not use grounding adapters.
NOTE: The bath with airjets model number is printed on a label near the blower motor. This label also
identifies the electrical rating.
Your Kohler bath with airjets is equipped with a cord and plug. The blower motor has been wired
at the factory. A licensed electrician must install a dedicated GFCI-protected, 120 V, 15 A, grounded
outlet. Locate the outlet behind the bath, and within 24″ (61 cm) of the blower motor.
Plug the blower motor into this outlet.
Clean the area of all dust and debris.
Blower Motor
GFCI-Protected
Receptacle
Kohler Co. 9 1040292-2-C
To Next Page
Loading...
Need help?
General
