Roughing-in
IMPORTANT! A4″ D. waste outlet must be used for this
installation.
IMPORTANT! A flange is not required with this installation. For
ease of installation, do not install a flange.
IMPORTANT! The supply location is not standard, and must be
installed at the location shown.
IMPORTANT! If the subfoor is thin OSB, a 1/2″ (1.3 cm) plywood
support under the subfloor is recommended.
A1″ (2.5 cm) gap between the toilet and the wall is required.
Locate the supply following the diagram.
1-3/4"
(4.4 cm)
4-1/8" (10.5 cm)
9-5/8"
(24.4 cm)
3/8" NPS Supply
1-9/16"
(4 cm)
15-3/8"
(39.1 cm)
15-9/16"
(39.5 cm)
14-1/16"
(35.7 cm)
7-1/8"
(18.1 cm)
1"
(2.5 cm)
15-1/2"
(39.4 cm)
17-5/16"
(44 cm)
12"
(30.5 cm) RI
1052867-2-B 4 Kohler Co.
To Next Page
Loading...
