1. Install the Tank
Position the sealing ring on the valve nut.
Position two carriage bolts in the notches on the mounting plate.
Thread the supplied supply hose onto the water inlet on the
bottom of the tank.
Position the tank on the bowl, aligning the carriage bolts with the
corresponding holes in the bowl and running the supply hose
through the corresponding hole.
Slide a washer onto each carriage bolt and thread a nut onto each
carriage bolt.
Wrench tighten. Do not overtighten.
Washer
Nut
Valve Nut
Sealing Ring
Supply Hose
Mounting
Plate
Valve Nut
Mounting
Plate
Carriage Bolt
Carriage Bolt
Kohler Co. 5 1052867-2-B
To Next Page
Loading...
