Tools and Materials
Thank You For Choosing Kohler Company
We appreciate your commitment to Kohler quality. Please take a few
minutes to review this manual before you start installation. If you
encounter any installation or performance problems, please don’t
hesitate to contact us. Our phone numbers and website are listed on
the back cover. Thanks again for choosing Kohler Company.
Before You Begin
CAUTION: Risk of personal injury or product damage. Handle
with care. Vitreous china can break or chip if the product is
handled carelessly.
IMPORTANT! Record the model number (from the label on the box)
in the Homeowners Guide for reference.
Observe all local plumbing and building codes.
Carefully inspect the new toilet for damage.
If the existing toilet does not have a supply shut-off valve below
the tank, install one before installing the new toilet.
Provide an adequate amount of clearance for the toilet’s lift rod.
Clearance values are measured from the floor to the top of the
fully extended rod.
•
K-3360, K-3612, K-14224 and K-14230 require 28″ (71.1 cm) of
clearance.
•
K-3357 require 32-5/8″ (82.9 cm) of clearance.
10" Adjustable
Wrench
Supply
Shut-Off
Valve
Tape
Measure
Pipe Wrench
Tubing Cutter
Hacksaw
Level
Wax Seal
Putty
Knife
Plus:
• 5/16" T-Bolts w/ Nuts
and Washers
• Screwdriver
• Safety Glasses
• Sponge
1021796-2-B 2 Kohler Co.
To Next Page
Loading...
