Test the Functions
Wrap the toilet seat with plastic wrap. This will prevent water
from spraying from the toilet during testing.
Plug the power cord into the electrical outlet. The seat will go
through a power-up sequence where the power indicator LED
will flash amber. Once power-up sequence is complete and the
tank is full, the indicator will turn green.
Face the toilet, then place your hand or a damp wash cloth on the
right side of the seat approximately 1/3 from the front of the seat
(as illustrated).
Proceed to the ″Keypad and Panel Diagram″ and “Operation”
sections in the Homeowner’s Guide to test the various seat
functions.
Power Button
Plastic Wrap
Clips
Kohler Co. 9 1097712-5-A
To Next Page
Loading...
