Install the Remote Holder (cont.)
Install the caps to cover the screws.
Position the remote into the holder with the user preset icons
facing up.
Install Using Double-Sided Tape
Remove the paper from one side of each of the tape squares.
Install a tape square in each of the rectangular areas located on
the back of the remote holder.
NOTE: Before mounting the remote holder, verify the rectangular
indent is toward the bottom.
Remove the paper from the tape squares.
Press the remote holder into place.
Position the remote into the holder with the user preset icons
facing up.
Kohler Co. 15 1093479-2-A
To Next Page
Loading...
