7. Install the Water Supply
All Installations
IMPORTANT! Optional bidet water supply for the K-6300 Bowl is
shown. Do not install a second water supply unless a hidden bidet
seat will be installed.
Install the water supply pipes, following all local codes.
Connect the waste pipe following all applicable local codes.
Installations With a Bidet Seat
Optional: Install the bidet water supply and a quarter turn, 1/2″
NPT supply shut-off.
IMPORTANT! The bidet supply shut-off must extend 3″ (76 mm)
minimum to 4″ (102 mm) maximum from the finished wall to allow
access to the handle. The supply shut-off handle should be no
higher than 5/8″ (16 mm) from the center of the water supply.
3-1/2" (89 mm)
Maximum Clearance
from the Front of
the Finished Wall
5/8"
(16 mm)
Bidet Water Supply (Optional)
1142998-2-D 12 Kohler Co.
To Next Page
Loading...
