Troubleshooting (cont.)
Symptoms Cause Recommended Action
2. Leaks
from
behind
bowl.
A. Gaskets not
positioned
correctly.
A. Remove the bowl and
inspect all the gaskets.
Reposition the gaskets if
needed. Lubricate the
gaskets so they slide in or
over the mating part they
seal. Reinstall the bowl,
making sure the gaskets
stay in the correct positions.
3. Bowl is
loose on
the
threaded
rods.
A. Threaded rods are
protruding too far
from wall.
A. Remove the bowl. Adjust
the threaded rods until they
are 3″ (76 mm) from the
finished wall.
B. Fasteners are not
tight.
B. Make sure the pegs are
oriented with the notches
facing down. Use the tool to
secure the bowl. Refer to
the ″Install the Bowl″
section.
1287824-2-A 16 Kohler Co.
To Next Page
Loading...
